A wide selection of Volvo Penta Engines parts for MD2010 including overhaul kits, gaskets, oil and fuel filters, seal sets, bearings, connecting rods, engine mounts, header tank caps etc.
A comprehensive overhaul kit which includes the main components that you will need to overhaul your tired and smoking Volvo Penta MD2010
This overhaul kit includes the following parts:
Gudgeon pins x2
Gudgeon pin circlips x4
A very comprehensive set of quality gaskets and seals for your Volvo Penta MD2010 engine. Set includes:
x2 water pump gaskets
front timing cover gasket
front timing cover oil seal
rear crankshaft oil seal
Genuine OE connecting rod for Volvo Penta MD2010. It comes with small end bush fitted and reamed to size. 2 big end nuts included.
UK delivery is by 1st class Royal Mail. European and Worldwide also available.
A genuine Volvo Penta MD2010 starter ring gear, to fit versions A to D. Volvo Penta part number 861973:
Number of teeth
A set of genuine Volvo Penta MD2010 head bolts.
UK delivery is by 1st class Royal Mail. European and Worldwide delivery also available.
Volvo Penta MD2010 cylinder head valve springs set. These are genuine replacement OE parts suitable for the following engine codes:
UK delivery is by 1st class Royal Mail or courier. Worldwide shipping is...
Genuine OEM cylinder head valve set to fit Volvo Penta MD2010.
Set includes: 2 exhaust and 2 inlet valves
UK delivery is by 1st class post or courier. European and Worldwide shipping is also available.
15W-40 Marine engine oil. An high performance (HPE) multigrade diesel engine oil specially designed for the lubrication of high-speed marine engines operating under severe conditions and under all weather conditions. Details:
A high quality base oil...
A genuine oil pump to fit Volvo Penta MD2010A, MD2010B, MD2010C, MD2010D.
Includes all the parts shown in the photo.
UK mainland delivery is by 1st class Royal Mail or courier. European and Worldwide shipping is also available.
A genuine OE Volvo Penta Md2010 oil pressure relief valve (Reduction Valve)
x1 relief valve
x1 'O' ring
To fit engine types, MD2010, MD2010B, MD2010C, MD2010D
Volvo part number 3583580
Delivery is by 1st class...
A genuine replacement part for Volvo Penta MD2010 engines.
Fits MD2010A, MD2010B, MD2010C, MD2010D,
Volvo Penta part number 861827
Shipping is by first class post or courier. Worldwide shipping is also available...
Genuine OE Volvo Volvo Penta MD2010-C & MD2010-D Dipstick.
UK delivery is by 1st class Royal Mail. European and Worldwide shipping is also available.
A set of quality Volvo Penta MD2010 connecting rod bearings available in the following sizes.
UK delivery is by Royal mail first class post or courier , European and Worldwide delivery is available...
Genuine OE filter manufactured by Perkins and suitable for Volvo Penta MD2010 A, B, C, D engine.
Choose from a 'Spin-on' filter (diameter 78 mm) or Cartridge filter (diameter 88 mm)
UK shipping is by Royal Mail or courier, worldwide shipping is also...
LUCAS Magnum SAE 15W40 engine oil is ideal for Volvo Penta engines and meets or exceeds recommendations for Volvo VDS-3 oil. It is designed to last up to twice as long as plain 15W-40 oils.
Lucas say it holds much more soot in suspension than...
Excellent quaility 'spin-on' oil filters for this range of Volvo Penta MD2010 engines.
These are genuine Perkins OE parts and suitable for Volvo Penta MD2010 version.
UK shipping is by Royal Mail or courier, worldwide shipping is also available.
Quality replacement Rear engine mounts for your Volvo Penta MD2010. Fitting the correct type of mount for the weight and use of your engine is crucial in not only maintaining structural safety, but also in reducing to a minimum the transmission...
Replacement front engine mounts for Volvo Penta MD2010. Fitting the correct type of mount for the weight and use of your engine is crucial in not only maintaining structural safety, but also in reducing to a minimum the transmission of engine vibration...
New genuine Volvo Penta MD2010 injector, includes:
x1 Return pipe washer
x1 Injector to head copper washer
xi Return pipe fixing nut
Volvo part number 3580078
Fits engine versions...
A genuine OE fuel filter assembly kit for your Volvo Penta MD2010 engine, fits all versions.
The following items are included in the kit:
x1 Filter head
x1 Fuel filter
x2 Pipe connecting banjo bolts
x4 Banjo sealing...
An excellent injector nozzle for Volvo Penta MD2010 that has the correct type of tip for this engine.The nozzle is the only wearing part of the injector and with new injectors becoming prohibitively expensive, the alternative option of...
Set of genuine Volvo Penta MD2010 injector pipes to fit the following engine types:
Volvo Part numbers 3580080, 3580081
Fits engine versions MD2010A, MD2010B, MD2010C & MD2010D
UK shipping is by Royal Mail or...
We are pleased to offer fully reconditioned Volvo Penta MD2010 injector pumps. These are disassembled, completely cleaned, inspected and all worn parts are reconditioned or replaced. The pump is then reassembled using all new seals and then...
For Volvo Penta MD2010 we stock an original water pump. These pump also come with a backplate gasket and a tube of silicone sealant.
UK delivery is by Royal Mail or 24hr courier. European and worldwide shipping is available
Genuine Perkins/Volvo fuel lift pump for the Volvo Penta MD2010 engines, fits all versions. Kit includes:
x1 Fuel lift pump
x2 Banjo bolts
x4 Copper sealing washers
Tube of Hylomar
UK delivery is by 1st class Royal Mail or...
Top quality alternator and water pump belts which are the correct fitment for Volvo Penta MD2010 marine engines. The belts are produced by 'Gates', the leading manufacturer of after-market belts. UK delivery is by 1st class Royal Mail. European and...
A genuine original equipment part high temperature switch for Volvo Penta MD2010. This is a high temperature switch (thermo monitor 873598) that will work a warning light or alarm. Please note this is not a sender to work a gauge, for engine...
Volvo Penta MD2010 Oil pressure switch is designed to provide warning to the operator when the oil level is low. Balanced to the oil pressure, an engine requires for effective oil circulation.
UK delivery is by 1st class Royal Mail. European and...
Volvo Penta MD2010 thermostat retaining spring, a genuine replacement part.
UK delivery is by 1st class Royal Mail or courier. Worldwide shipping is available.
Genuine OE thermostat kit for Volvo Penta MD2010 series engines. Details:
34 mm diameter
Includes gasket and sealant
Fits engine versions MD2010-A, MD2010-B, MD2010-C, MD2010-D
Volvo thermostat part number...
Manufactured by Jabsco, this is the bronze sea water pump fitted to Volvo Penta MD2010 marine engines.
It fits the following versions:
The pump is a high quality original equipment part. To finish the job off...
The end covers on these pumps tend to wear, resulting in poor sealing of the impeller, lower flow rates and premature failure of the impeller vanes. Our end cover kit engine mounted raw (sea) water pump Volvo Penta MD2010 is made from high quality...
Excellent quality impeller kits and pump service kits for the original engine driven raw water pump for Volvo Penta MD2010 engine. Our impellers are manufactured from the correct grade of high quality neoprene rubber and are molded on to a machined brass...
A pair of heat exchanger end cover caps for Volvo Penta MD2010. These are genuine OEM parts, and can be purchased with a set of 6 marine grade (304) stainless steel hose clips. Choose from the following options:
MD2010 a, b end caps with or without...
Aftermarket Volvo Penta MD2010 Header tank cap.
Heat exchanger header tank cap to fit Volvo Penta MD2010 engines and fitted with the OE specification 13lbs spring. This is a high quality part, with a zinc plated cap, stainless steel spring, brass...
A quality glow plug suitable for Volvo Penta MD2010. Easy to change and a great help to cold starting. This is a 12 volt 'Rapid glow' type - and uses full battery voltage. UK delivery is by 1st class Royal Mail. European and Worldwide delivery is...
Quality hand made gaskets to fit your Volvo Penta MD2010 Heat Exchanger overhaul gasket set. Includes:
Head to exchanger gasket
Exhaust outlet gasket
Tube of Hylormar gasket sealant
Delivery is by 1st class Royal Mail or courier...
Volvo Penta MD2010 Exhaust outlet, a high quality replacement 316 stainless steel exhaust outlet that provides a long-term solution to the 'achilles heel' of theses engines, which is terminal corrosion in the original factory fitted cast iron exhaust...
The 500FG is a quality aftermarket bulkhead mounted pre-filter. It features a turbine filtration system and is similar to the Racor 500FG. It is designed to filter various contaminants such as water, dirt, rust, and algae
Turbine filters are...
We stock excellent quality replacement starter motor for the entire range Volvo Penta MD2010. They are manufactured by one of the Bosch group of companies.
Specifications: *See the images
Voltage 12, 0.8 KW
No. of teeth 8
Volvo Penta MD2010 exhaust outlet gasket UK delivery is by 1st class Royal Mail. European and Worldwide delivery is available.
An original genuine replacement oil filler cap to fit your Volvo Penta MD2010 series engine:
Thread diameter 41mm
To fit the following MD2010 engines ending with build codes:
UK delivery is by...
A top quality Volvo Penta Alternator (pulley not included), 12 volt, 70 amp, 'isolated earth', direct replacement alternator to fit the following Volvo Penta engines:
We include in the kit a packet of the correct...
Genuine Volvo Penta expansion tank sealing ring.
Volvo Part number 1543751
Fits MD2010, MD2010B, MD2010C, MD2010D
Fits MD2020, MD2020B, MD2020C, MD2020D
MPM propeller shaft grease is specially developed for marine applications. The grease has a very high resistance to water washout and is therefore particularly suitable for use in stern glands. This grease is also suitable for:
Lubricating rudder and...
Rydlyme Marine is a safe, biodegradable marine descaler developed to dissolve problematic fouling mediums including calcium, rust, mussels, barnacles, tiger shells and other scale formed mineral deposits that hinder the performance of vital water systems...
A quality Volvo Penta split collar zinc anode for (4 blade) folding propellers. Manufactured to US military specification by Tecnoseal in Italy, one of the worlds leading suppliers of sacrificial anodes for cathodic protection in the leisure...
A quality Volvo Penta split collar zinc anode for (2 and 3 blade) folding propellers. Manufactured to US military specification by Tecnoseal in Italy, one of the worlds leading suppliers of sacrificial anodes for cathodic protection in the...
A genuine Volvo Penta MD2010 standard instrument panel to fit the following engine versions:
MD2010A, MD2010B, MD2030C and MD2030D
Two options are available:
Panel for use with a push start button Volvo part number 872798 or
Genuine Volvo Penta propeller shaft Stuffing box / Stern gland kit, for Volvo Penta MD2010, MD2020, MD2030 and MD2040 engines. Kit includes:
Seal Install protector
Clamp anti-pinch plate
Tube of grease
x 2 Nuts and...
A quality aftermarket rubber hull mounting cover for Volvo Penta 110S, 120S and MS25S saildrive's.
Equivalent to Volvo Penta part 854932
Suitable for the following types of saildrive.
S120C, 120SB, 120S-E , 120S-D,
A genuine OE Volvo Penta Rubber Diaphragm Seal and gasket kit for 110S 120S 130S 150S and MS25S.
Volvo part number 21389074
Fits 110S, 120S, 130S, 150S and MS25S sail drives
UK delivery is by courier, Worldwide shipping is...